Mediacom, along with phone, internet, Tv, and cable box services, supplies universal remotes as well. A Mediacom universal remote can be used to control a number of home entertainment devices. It comes preprogrammed for a Mediacom cable box. However, control different devices like TV, DVD player, VCR, you need to program it with Mediacom remote codes.
Programming Mediacom Remote with Code
Step 1: Turn on the device that you want to pair the remote.
Step 2: Find the corresponding ‘Device Type’ button on the remote and press it. Suppose you want to program your remote to control a DVD player, then press the ‘DVD’ button on the remote.
Step 3: Press and hold the ‘Setup’ button until the pressed ‘Device Type’ button flashes two times.
Step 4: Find the code for your device in Device code finder. Select the correct model of the remote you are using and ensure you get the valid Mediacom remote code for your device.
Step 5: Using the number buttons, enter the code that you found.
Step 6: Press the ‘Power’ button pointing the remote at your device. The device should turn off.
Step 7: If the device is switched off, switch it on again and test for other remote commands, including Volume up and down, Channel change buttons, etc.
Step 8: If the device responds correctly, press the ‘Setup’ button to save the code, and the programming process is complete.
Step 9: If the device doesn’t respond positively to the remote commands, you have to redo these steps with a different Mediacom remote code.
Programming Mediacom Without Code
Suppose you could not find the right code for your device, then no need to worry. Now, you can program your Mediacom remote to operate your device using a code search method. Here the device tries all the codes to pair itself with the remote and finds a suitable code. Follow the instructions below to program your remote using the Code Search method.
Step 1: Switch on any of the devices that you like to control.
Step 2: You can find ‘TV,’ ‘DVD,’ ‘AUDIO,’ and ‘CBL’ buttons on the remote. Press the correct ‘Device Type’ key respective to the type of device you are pairing the remote with and hold it until the light for the selected button blinks.
Step 3: Now, press the ‘Setup’ button to enter the setup mode to find the right code for your device. The selected ‘Device Type’ light flashes twice.
Step 4: Using the numeric keypad, enter the code 9 9 1. The light of the selected ‘Device Type’ blinks two times.
Step 5: Press the ‘Power’ button.
Step 6: Point the remote at the device you are programming and repeatedly press the ‘Channel Up’ (CH +) button at the intervals of five seconds. Keep doing this until the device turns off.
Step 7: The switching off of the device indicates that the device has found the right code to pair with the remote. Press the ‘Setup’ button to save the code.
Step 8: Remember to check if the device responds correctly to other commands of the remote. If it does, you are good to go.
Step 9: If you face any problems, you need to repeat this process so that the device finds the correct Mediacom remote code.
Mediacom Remote Codes
Here are the Program Codes for Mediacom Remote. Enter these codes when the device asks for the code to control your TV or any Home Entertainment Device.
4-Digit Codes for Mediacom Remote
1376 1877 0476 3560 1284 1584 1982
Mediacom Universal Remote 5-Digit Codes
51376 53560 51982 51877 42815 45818
This is how you program a Mediacom remote code. I hope this article was helpful. Thanks for reading this, and for more articles like this, visit our website.